Ultimaker Connect Operation Tutorial (3D Printing Software)
1. Create a new group
II. Add 3D printer to the group
one, Create a new group
II. Add 3D printer to the group
III. Start 3D Printing
one, Create a new group
Before you begin, please make sure your computer is successfully connected to the internet.
1. In Ultimaker Cura, select "Prepare" to prepare the interface, and then select "Add Printer" from the drop-down menu on the right to add a new Ultimaker 3D printer group.
2. Name the group for the Ultimaker 3D printer in Printer Name.
3. Select to add, edit, or remove Ultimaker 3D printers from the group.
4. Switch the interface to "Monitor" settings to configure the job schedule for the Ultimaker 3D printer. You can then check the production status at any time when 3D printing begins.
1. In "Monitor" mode, select "View printers" from the right-hand menu.
2. The Ultimaker 3D printer connected to the internet will be displayed on the page.
3. Click the blue "Add to group" button to add other network-connected Ultimaker 3D printers to the scheduling group.
4. This principle can be applied to schedule additional Ultimaker 3D printers for job creation.
1. After adjusting the object, confirm the nozzle and filament settings of the Ultimaker 3D printer, press the blue "Print over network" button in the lower right corner for remote control, and start 3D printing.
2. Select the desired 3D printer group.
3. After successfully connecting to the Ultimaker 3D printer, select "Show print jobs" to view the 3D print job schedule.
4. When you start 3D printing, the page will display various detailed information, mainly including the estimated production time, nozzle, and filament.
5. The "Queued" section below will display important notes for printing. For example, the "Printer-2" printer needs to have its cable replaced with a PLA cable instead of the original ABS cable.
6. The menu allows you to select "Move print job to top" and "Delete print job" to adjust the order of 3D print jobs as needed.
7. After the filament replacement and scheduling adjustment are completed, select "Override configuration and start print" and the Ultimaker 3D printer will start the operation remotely.